TM  10-3930-643-34 GENERAL  SUPPORT  PROPELLER 16-1.  Front  Differential AND  PROPELLER  SHAFTS  MAINTENANCE.  (cont) Carrier   Assembly. DISASSEMBLY  (cont) NOTE 20. 21. 22. 23. 24. 25. 26. 27. 28. The following steps (20 thru 28) is the  disassembly  procedure  of  the differential  carrier  assembly  for vehicles  S/N  2000  and  below  and 2904  and  above.  The  disassembly procedure  of  the  differential carrier assembly for vehicles S/N 2001 to 2903, proceed to steps (29 thru 38). Using  1-1/2  socket  and  socket  wrench handle.    remove nut (36) , and washer (37) from carrier (54). Using  suitable  puller,  remove  yoke (38) from deflector (39). Using  a  flat  tip  screwdriver,  remove deflector  (39). Using  a  5/8  socket  and  socket  wrench handle ,   remove eight bolts (40), washers  (41),  two  bolts  (42),  shim (43) and items 44 thru 53 as an assembly. Using an arbor press, remove items 45 thru 49 as an assembly from cage (44). NOTE Identify and mark location of all cups and cones on gear or in bearing cage. Relationship between cups and cones must be maintained  during  reassembly. Remove ring (46) from gear (45). Remove bearing (47) and cone (49) from gear (45). Using  a  flat  tip  screwdriver,  remove and discard seal (50) and cone (48) from cage (44). Using  a  brass  punch  and  hammer,  remove (Sheet 5 of 13) cup (51), shim (52) and cup (53). Go to sheet 6 16-6