| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-6. Forward and Reverse Steering Gear Assembly. (Sheet 10 of 13)
ASSEMBLY (cont)
66.
Install two washers (29) and thrust
washer (30).
Before installing friction plates
(26 and 27), friction plates must
be soaked in transmission oil for
one hour. Failure to follow this
procedure will result in damage
to the transmission.
67.
68.
69.
70.
71.
72.
Install 18 new wave springs (28) and
nine plates (27 and 26) in the
following order:
One plate (27), two
wave springs (28) and one plate (26).
Be sure that open ends of new wave
springs (28) have bend facing up.
Each pair of new wave springs (28)
must have opens ends alined with each
other.
Continuing stacking in order until
stack is 1 inch from top of
housing
(42).
Insert guide pins at each oil hole
slot, refer to illustration.
Continue stacking plates and springs
using guide pins to properly aline
teeth, until all have been installed.
When properly alined, plates will
drop freely into place.
Install plate (25). Do not remove
guide pins.
Using an adapter, gradually press
plates (27 and 26) and 18 new springs
(28) into housing (42). Do not press
all at once.
Press and release
gradually in 1/4 inch increments to
allow springs to seat properly.
Go to sheet 11
15-82
|
