| |
GENERAL SUPPORT
15-6. (Forward
ASSEMBLY
58.
59.
60.
61.
62.
63.
64.
65.
TM 10-3930-643-34
TRANSMISSION MAINTENANCE.
and Reverse) Steering Gear Assembly. (Sheet 9 of 13)
Insert piston (33) with new
preformed packing (34) end entering
cylinder first.
Using a plastic hammer, tap piston
(33) into place.
Install new retaining ring (36) in
housing (42). Be sure that open
space between new
retaining
ring
(36) end does not aline with oil
holes.
Install shaft (40) and cylinder (41)
into housing (42).
Install new retaining ring (32) into
housing (42).
Be sure that open
space between new
retaining ring
(32) does not aline with oil holes.
Using a plastic hammer,
install
three pins (44), driving three Pins
(44) down until heads of three pins
(44) just clear upper surface of
retaining ring (36).
Position housing (42) in arbor press
at reverse gear side.
Install plate (31).
Go to sheet 10
15-81
|
