| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-5.
Second and Third Gear Assembly. (Sheet 10 of 17)
ASSEMBLY
49.
50.
51.
52.
53.
54.
55.
56.
NOTE
Wait until shaft and cylinder
assembly is cool before continu-
ing.
Install pistons (33 and 29) in
cylinder (38).
Rotate pistons (33 and 29) to check
clearance.
Remove pistons (33 and 29).
Install new preformed packing
(34)
and new seal ring (35) in piston (33)
on second gear side of shaft (39).
Coat piston (33) with
clean
lubricating oil.
Insert piston (33) with new preformed
packing (34) and new seal ring (35)
end entering cylinder (38) first.
Using a plastic hammer, tap piston
(33) into place.
Turn over shaft (39) so that third
gear side is facing up.
Go to sheet 11
15-65
|
