| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-5.
Second and Third Gear Assembly. (Sheet 3 of 17)
DISASSEMBLY (cont)
8.
Using two C clamps, depress plate
(12) into third gear side of housing
(40).
Use care when removing retaining
ring.
Take care not to let
fingers inside housing in case “C”
clamps fail and plate tension is
released.
9.
Using a machinist’s scribe, remove
and discard retaining ring (11).
10.
Remove C clamps from plate (12).
11.
Remove plate (12).
Wave springs are thin and have
sharp edges.
Use care when
handling them to avoid cutting
hands and fingers.
Use care when
removing
and
handling clutch plates.
Avoid
nicking or
scratching
friction
surfaces.
12.
Using snap ring pliers, remove and
discard retaining ring (16).
13.
Remove plates (13), plates (14) and
springs (15) to allow a gear
puller
to be installed on gear (20).
Discard springs (15).
Go to sheet 4
15-58
|
