TM  10-3930-643-34 GENERAL  SUPPORT  TRANSMISSION  MAINTENANCE.  (cont) 15-3. Transmission  Assembly.  (Sheet  22  of  26) ASSEMBLY  (cont) 155. 156. 157. 158. 159. 160. 161. 162. 163. 164. 165. 166. 167. 168. Install thrust washer (35), thrust bearing (34), washer (33), spacer (32) and two bearings (31). Install two new preformed packings (23). Apply Permatex sealant No. 2 to housing  (30)  mounting  surface. Position  housing  (30),  being  careful not to dislodge two new preformed packings  (23). Using a 9/16” socket and socket wrench handle, install six lock washers (29) and bolts (28). Install clutch pack (27) and two seal rings (26). Using a 1-1/8”   socket and torque wrench,   install washer (25) and bolt (24). Tighten  bolt  (24)  to  100-150 lb-ft. Bend washer (25) back on shaft (27). Using  a  wooden  block,  press  bearing (22) into cover (20). Position new gasket (21) and cover (20). Using a 1-1/8 and 9/16” open end wrench, install nine lock washers (19) and bolts (18). Install plug (17) in cover (20). Install elbow (16) in cover (20). Using an 11/16” open end wrench, connect hose assembly (15). Go to sheet 22 15-44