| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-3.
Transmission Assembly. (Sheet 16 of 26)
ASSEMBLY (cont)
1030
Install gear (133) by sliding it
between case wall and clutch pack
(120) to position it, long side of
hub up, on it’s bore in transmission
housing.
104.
Engage splines of shaft (132) into
gear (133) and seat clutch pack
(128) in gear (133).
105. Using a wooden dowel, install spacer
(116).
106.
Using a bearing installation tool,
install gear (115) with the long hub
side of gear toward spacer (116).
107. Block bottom end of shaft (129) with
wood blocks.
108.
Position
bearing
(114)
with
retaining ring groove up.
109 l
Using a bearing installation tool,
drive bearing onto shaft (129).
110.
Using snap ring pliers, install snap
ring (113).
111.
Heat bearing (135) to 250 degrees F in
oil or oven.
112.
Using insulated gloves and bearing
installation tool, seat bearing (135)
on shaft (132).
Go to sheet 17
15-38
|
