| |
TM 10-3930-643-34
GENRAL SUPPORT TRANSMISSION MAINTENANCE. (cont)
15-2.
Torque Converter Charging Pump. (Sheet 2 of 6)
DISASSEMBLY
1.
2.
3.
4.
5.
6.
7.
8.
Using a 9/16" socket and socket
wrench handle, remove
three bolts
(l), flange (2) , seal (3), gasket (4)
and ring (5) from
drive side of
charging pump.
Discard seal (3) and
gasket (4).
Remove four screws (6), seals
(7),
bolts (8), plate (9) and preformed
packing (10).
Discard four seals (7)
and preformed packing (10).
Using slip joint pliers, remove pins
(11 and 12) from plate (9).
Using a rubber mallet, remove case
(13) and preformed packing (14) from
drive side of charging pump.
Discard
preformed packing (14).
Remove gear (15), pin (16) and items
17 thru 21 as an assembly.
Using snap
ring pliers,
remove
retaining ring (17), gear (18), pin
(19) and retaining ring (20) from
shaft (21).
Using a rubber mallet, remove spacer
(22) with preformed packing (23) and
items 24 thru 27 as an assembly.
Discard preformed packing (23).
Using slip joint pliers, remove pins
(24, 25, 26 and 27) from spacer (22).
Go to sheet 3
15-18
|
