| |
TM 10-3930-643-34
GENERAL SUPPORT TRANSMISSION MAINTENANCE.
15-1.
Torque Converter. (Sheet 12 of 15)
ASSEMBLY
62.
Using a 9/16" socket and torque
wrench, install items 48 thru 45 as
an assembly and bolt (44) into
housing (13).
Tighten bolt (44) to
37 lb-ft.
63.
Using a flat tip screwdriver, install
hub (43) and retaining ring (42).
64.
Using snap ring pliers, install
retaining ring (37) and new seal
(36) to shaft (35).
65.
Using hammer and brass drift, drive
shaft (35) into turbine (38) in
direction of arrow shown.
NOTE
Be sure inner bearing race (39a)
is fully seated on shoulder of
shaft (35).
66.
Using a bearing installation tool
install inner bearing race (39a) on
shaft (35).
67.
Using snap ring pliers, Install
retaining ring (41) onto outer race
of bearing assembly (39).
NOTE
Be sure that retaining ring (41)
is fully seated on shoulder of
housing (40).
68.
Using a bearing installation tool
install outer bearing assembly (39)
and retaining ring (41) as an assembly
into housing (40).
69.
Install items
assembly into
39a thru 35 as an
housing assembly (40).
Go to sheet 13
15-13
|
