| |
TM 10-3930-643-34
GENERAL SUPPORT ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE. (cont)
13-8.
Pistons, Connecting Rods and Connecting Rod Bearings. (Sheet 12 of 12)
INSTALLATION (cont)
44.
Using a 5/8” socket and socket wrench
handle, remove two bolts (1), cap (2)
and bearing
half (3) in lower
crankcase.
45.
Place suitable length of 0.010 inch
virgin lead wire across bearing in
cap.
46.
Using a 5/8” socket and torque
wrench, install bearing half (3), cap
(2) and two bolts (1). Tighten two
bolts (1) to 115 lb-ft.
47.
Remove lead wire and measure with a
micrometer to
determine
running
clearance.
48.
Using a
feeler gage, measure
connecting rod (4) end clearance.
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
13-60
|