| |
TM 10-3930-643-34
GENERAL SUPPORT
13-6. Rear Oil
INSTALLATION
ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE.
Seal. (Sheet 6 of 6)
13.
14.
Position rear crankshaft wear sleeve
and seal installating tool onto
the
centering plate, then tighten thrust
washer by turning hex nut, as shown.
Tighten hex nut until it reaches the
end of its travel, at which point new
oil seal (1) and new wear sleeve (3)
are correctly installed.
Remove hex nut, thrust washer, rear
crankshaft wear
sleeve
and seal
installing tool, four
allen head
screws and centering plate.
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
13-43
|
