| |
TM 10-3930-643-34
GENERAL SUPPORT
13-6.
Rear Oil
INSTALLATION
6.
7.
8.
ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE.
Seal. (Sheet
Before installing sleeve
check the seal bore for
4 of 6)
and seal,
chamfer.
If no chamfer is found, use a file
to break the edge of
the bore.
Failure to follow this procedure
could result in damage to
casing
when
sleeve
and
seal
are
installed.
Be careful not to
damage the bore while filing the
chamfer edge.
Lubricate lip of new oil seal (1)
with grease.
NOTE
Seal must be installed onto side
of sleeve with chamfer on O.D. to
avoid damage to
seal lip, as
shown.
Assemble new oil seal (1) onto new
wear sleeve (3) by pushing new
oil
seal (1) in the direction of
the
arrow.
Install flywheel housing
(2) to
crankcase, refer to paragraph 13-7.
Go to sheet 5
13-41
|
