| |
TM 10-3930-643-34
GENERAL SUPPORT ENGINE, FUEL, EXHAUST AND COOLING MAINTENANCE.
13-4.
Crankshaft. (Sheet 9 of 9)
INSTALLATION
32.
Position contact
pin
of dial
indicator against end of
crankshaft
(8).
Do not use a metal hammer to move
crankshaft.
Do not contact
machined surfaces of
crankshaft
with a metal prybar.
Failure to
follow this procedure could
result in damage to crankshaft.
33.
Using a pry bar, move crankshaft (8)
forward, then backward.
34.
Measure end play of crankshaft
(8).
Maximum end play is 0.020 inch.
35.
For installation of new wear sleeve
(12), refer to paragraph 13-7.
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
13-33
|
