TM  10-3930-643-34 GENERAL  SUPPORT  ENGINE,  FUEL,  EXHAUST  AND  COOLING  MAINTENANCE. 13-3. Crankcase and Cylinder Sleeves. (Sheet 10 of 11) ASSEMBLY NOTE Preformed  packings  must  be installed in the following order: bottom, center and top. 41. 42. 43. 44. 45. 46. Coat 18 new preformed packings (18) in engine crankcase with clean engine oil and install 18 new preformed packings (18) on six sleeves (16). Install new shims (17) in cylinder counterbores. Coat sealing surfaces with clean engine oil. Using a hydraulic press, install six sleeves (16) into bores. Make  sure  that  sleeves  are  installed into same cylinders from which they were removed. Check sleeve protrusion again. Make additional  adjustments,  if  necessary. Using a flat brass pump, install two dowels (15). Coat threads of two bolts (9) with permatex #2. Using a 1/2” socket and socket  wrench  handle,  install  baffle (14), new gasket (13), cover (12), two washers (11), lock washers (10) and bolts (9). Go to sheet 11 13-23