GENERAL  SUPPORT  ENGINE,  FUEL,  EXHAUST  AND 13-1. Front INSTALLATION 25. Using a handle, 26. Install (16). 27.  Install (14), two washers (13), bolts (12), washers  (11),  bolts  (10),  six  washers (9) and bolts (8) in rear of engine. 28. Using a 9/16” socket and socket wrench handle, install new gasket (7), elbow (6), three washers (5) and bolts  (4). 29. Using  a  flat  tip  screwdriver,  tighten clamp (3). 30. Install hose (2). 31. Using a flat tip screwdriver, tighten two clamps (1). NOTE Return M10A Forklift to original equipment  condition. TN  10-3930-643-34 COOLING  MAINTENANCE. Cover. (Sheet 6 of 6) 1/2” socket and socket wrench remove guide bolts. two washers (17) and bolts four washers (15). bolts END OF TASK 13-7