TM 10-3930-643-34 HYDRAULIC  SYSTEM  TROUBLESHOOTING  AND  MAINTENANCE. 12-14. Sideshift Cylinder (S/N 2001 and above). (Sheet 10 of 11) INSTALLATION 42. Fill  cylinder  assembly  (10)  with approximately  two  quarts  of  hydraulic fluid. 43. Attach  hoist  and  sling  to  cylinder assembly  (10)  and  position  on mounting  brackets. 44. Using a plastic hammer and 1-13/16" socket  and  socket  wrench  handle, install pin (9),   washer (8) and nut (7). Tighten nut (7) to a snug fit, then back off 1/8 turn. This procedure  is  necessary  to  allow cylinder  end  movement  between mountings  and  cylinder  assembly  (10). 45. Install two new preformed packing (6) and two unions (5). 46. Using a 7/8"   open  end  wrench,  connect hose assemblies (4 and 3). 47. Using a 1-13/16"   socket and socket wrench  handle,   install washer (2) and nut (1) to cylinder assembly (10) 48. Remove hoist and sling. 49. Check hydraulic fluid level. Add hydraulic  fluid,   refer to TM 10-3930- 643-12. Go to sheet 11 12-130