| |
TM 10-3930-643-34
HYDRAULIC SYSTEM TROUBLESHOOTING AND MAINTENANCE. (cont)
12-10. Boom Assembly. (Sheet 2 of 11)
REMOVAL (cont)
2.
3.
4.
5.
6.
7.
8.
9.
10.
NOTE
The following
are differences
between M1OA Forklift models.
Operate
boom control lever in
operator’s compartment to raise boom
on vehicles S/N 2001 and above only.
Remove pin (1) from front on vehicles
S/N 2001 and above only.
Position boom support (43) under boom
assembly (40) on vehicles S/N 2001
and above only.
Using a 1/2” socket and socket wrench
handle, remove six bolts (2), washers
(3), clips (4) and three clamps (5)
from front, right side of vehicle.
NOTE
Tag all hose and tube assemblies
before disconnecting to aid in
installation.
Uncouple quick-coupler to disconnect
tube assembly (6) from hose assembly
(7).
Cap hose assembly (7) to prevent
contamination from entering hydraulic
system.
Using a 1/2” socket and socket wrench
handle, remove six bolts (8), washers
(9) and three clamps (10) from front,
left side of vehicle.
Uncouple quick-coupler to disconnect
tube assembly (11) from hose assembly
(12).
Using a plug, cap hose assembly (12).
GO to sheet 3
12-76
|
