| |
TM 10-3930-643-34
TRANSMISSION TROUBLESHOOTING AND MAINTENANCE.
6-6.
Transmission Assembly. (Sheet 6 of 12)
REMOVAL
38.
Using a 1-1/8" socket and socket
wrench handle, remove plug (51)
and
gasket (52).
Discard gasket
(52).
Remove all gasket material from
mounting surfaces.
WEIGHT HAZARD
Weight of transmission assembly is
approximately 730 lbs.
Use
adequate hoist
and
cable for
removal and installation.
Keep
area
clear of
unnecessary
personnel.
Failure to follow this
procedure could result in SEVERE
INJURY .
39.
40.
41.
42.
43.
44.
Attach lifting eye to top of
transmission (53) at mounting
bore
for plug (51), refer to Appendix D,
part D-9 for fabrication of lifting
eye.
Attach a cable to lifting eye
installed in transmission (53) and
run
cable
through lifting eye
installed in floor plate (1) of
cab
to a winch mounted to the side of the
vehicle.
Raise transmission (53) high enough
to clear pin supports in rear vehicle
frame.
Tip transmission (53) to rear of
vehicle and lower.
Using a 3/4" socket and socket wrench
handle, remove eight
bolts (54),
washers (55) and bracket (56) from
transmission (53).
Using a 3/4" socket, socket
wrench
handle and a 3/4” open end wrench,
remove seven nuts (57), washers (58),
bolts (59), washers (60) and bracket
(61).
Go to sheet 7
6-41
|
