| |
TM 10-3930-643-34
TRANSMISSION TROUBLESHOOTING
6-6.
Transmission Assembly.
REMOVAL
1.
2.
3.
4.
5.
AND MAINTENANCE.
(Sheet 2 of 12)
Using floor jack, raise
vehicle 16”
inches off floor and
support
with
four jack stands.
Drill a hole through floor plate (1)
of cab directly above tapped hole in
top of transmission.
Make hole large
enough for a lifting eye capable of
supporting at least 4,000 lbs.
Install lifting eye in hole in floor
of cab and secure with washer and
hexnut.
Using a 9/16" open and box end
wrench, remove eight bolts (2)
disconnecting propeller shaft from
transmission rear output yoke to
rear axle.
Using a 9/16" socket and socket
wrench handle, remove four bolts
(3) disconnecting transmission to
hanger bearing propeller shaft from
transmission front output yoke.
Go to sheet 3
6-37
|
