TM  10-3930-643-34 ELECTRICAL  SYSTEM  MAINTENANCE.  (cont) 5-5. Intermediate Wiring Harness (S/N 2000 and below). (Sheet 2 of 4) REMOVAL (cont) 1. 2. 3. 4. 5. 6. 7. Using  diagonal  cutting  pliers, cut and discard tie straps (1). NOTE All wire must be tagged when removed from connector. Indicate whether wire is connected  to pin-type  or  socket-type  connector. Disconnect lead assembly (11) from power cluster under right side of cab. Disconnect  harness  assembly  (16)  from main harness in left, front of hydraulic  tank. Using a 9/16”   open  end  wrench,  remove nut (2), washer (3) and clamp (4) under left side of cab. Using a 3/8” open end wrench, disconnect  lead  assembly (5) from ground driven steering pump switch. Pull back boot (6). Using a flat tip screwdriver, disconnect  lead  assembly (7) from transmission. Go to sheet 3 5-46