| |
TM 10-3930-643-34
ELECTRICAL SYSTEM
5-3.
Main Wiring
INSTALLATION
74.
75.
76.
77.
78.
79•
80.
81.
82.
83.
84.
85.
MAINTENANCE.
Harness. (Sheet
Connect terminal (21) to fan
Position boot (20).
Apply silicone sealant over
connection.
14 of 15)
clutch.
entire
Using a 3/8” open end wrench, connect
wire assembly (19) at
terminal to
engine water temperature sender.
Apply silicone sealant over entire
connection.
Using a 1/2” open end wrench, connect
wire assemblies (18,17 and 16) at
terminals to alternator.
Apply silicone sealant over entire
connection.
Using a flat tip screwdriver, install
cover (15), two washers (14) and
screws (13).
Connect two wire assemblies (12) at
terminals to left work light.
Apply silicone sealant over entire
connection.
Connect three wire assemblies (11) at
terminals to right work
light and
frame.
Apply silicone sealant over entire
connection.
Go to sheet 15
5-39
|
