| |
TM 10-3930-643-34
ELECTRICAL SYSTEM MAINTENANCE. (cont)
5-3.
Main Wiring Harness. (Sheet 5 of 15)
REMOVAL (cont)
14.
Disconnect three wire assemblies (22)
at terminal from oil pressure switch
in left side of
engine.
15.
Using a 3/8” open end wrench,
disconnect terminal (23) from sensor.
NOTE
The following is a difference
between M10A Forklift models.
16.
Using a 9/16” socket and socket
wrench handle, remove
four bolts
(24), washers (25) and plate (26),
from vehicles S/N 2001 and above,
from left side of vehicle, underneath
battery compartment.
17.
Disconnect wire assembly (27) at
connector (28) in front, left side of
hydraulic tank.
18.
Using a cross tip screwdriver, remove
four screws (29) and washers (30).
Go to sheet 6
5-30
|
