TM  10–3930-643-34 ENGINE,  FUEL,  EXHAUST  AND  COOLING  TROUBLESHOOTING 4-14. Fuel  Injection  Pump,  Cover  Plate,  Adapter INSTALLATION 32. Position new gaskets (37 and 39), fuel injection pump (36) and cover (38), in right, rear side of engine. 33. Support fuel injection pump (36) and using a 1/2”   socket.,  socket wrench handle and a 1/2” open end wrench, install  washer  (35),  bolt  (34), bracket (33), washer (32) and nut (31). 34. Install two washers (30), bolts (29), washers (28) and nuts (27). 35• Using a 1/2”   socket and socket wrench handle,    install two washers (26), bolts (25), washer (18) and bolt (17). 36. Using a flat tip screwdriver, tighten clamp (23) to connect hose (24). 37. Using a 3/4”   open end wrench, connect hose assembly (22). 38. Using a 7/16”   socket,  socket wrench handle and a 7/16” open end wrench, install two straps (21), bolt (20) and nut (19). 39. Using a 3/4”   open end wrench, connect tube assemblies (16, 15, 14 and 13). Tighten fittings to 35 lb-ft. AND MAINTENANCE. and Drive Gears. (Sheet 7 of 9) Go to sheet 8 4-99