| |
TM 10-3930-64-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-32.
Fan and Clutch. (sheet 4 of 4)
INSTALLATION
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
Position fan clutch (14) in rear
of engine.
Apply Loctite 262 to shaft.
Using a 1 1/8”
socket and 1/2”
drive ratchet torque wrench,
install washer (13) and nut (12).
Tighten nut (12) to 150 lb-ft.
Install cup (11).
Connect wire assembly (10).
U s i n g a f l a t t i p s c r e w d r i v e r,
i n s t a l l s c r e w ( 9 ).
Install brace (8).
Connect ground cable (7).
Using a 9/16” socket and socket
wrench handle, install lock
washer
(6) and nut (5).
Install ground cable (7).
U s i n g a 1 / 2 ” s o c k e t a n d s o c k et
wrench handle, install washer
( 4 ) ,
lock washer (3) and bolt (2).
Install three new tie straps (1).
NOTE
Return M10A Forklift to original
equipment condition.
END OF TASK
4-140
|
