| |
TM 10-3930-643-20
ENGINE, FUEL, EXHAUST AND COOLING TROUBLESHOOTING AND MAINTENANCE. (cont)
4-24.
Ether Start Valve and Mounting. (Sheet 5 of 6)
INSTALLATION
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
rear, right side of
Using a 5/8” open
install nozzle (27)
open end wrench to
( 2 6 ).
Using a 3/8” open
Using a 7/8” open end wrench,
install thermostatic switch (28) on
engine.
end
wrench,
and use a 3/8”
i n s t a l l e l b ow
end
wrench,
install tube (25) and
23).
Install tube (22) and
Install three new tie
Install elbow (19) on
valve (18).
Using a 7/16” socket
nuts (24 and
nut (21).
straps (20).
ether start
and
socket
wrench handle, install ether
s t a r t
valve (18), two lock washers
( 1 7 ),
terminal (16) and two bolts (15) on
ether start system compartment.
Connect terminal (14).
Using a 3/8” open end wrench,
i n s t a l l n u t ( 1 3 ) .
Using two 5/16” nuts and two 1/2”
open end wrenches on each stud (12),
install four studs (12).
U s i n g a 1 / 2 ” s o c k e t a n d s o c k et
wrench handle, install two
spring
clips (11), four lock washers
(10)
and nuts (9).
Go to sheet 6
4-96
|
