| |
TM 10-3930-638-24&P
4 - 4 . T R A N S M I S S I O N M A I N T E N A N C E ( c o n t)
h. Third Clutch Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
DISASSEMBLY (cont)
10
11
12
13
14
15
16
CLEANING
Retaining ring (1,0)
Spring retainer (9)
Piston return
spring (11)
Third clutch shaft
drum and plug
assembly (15)
Clutch piston (12)
Outer clutch piston
seal (13)
Inner clutch piston
seal (14)
Remove and
discard
Remove
Remove
Invert
Remove
Remove and
discard
Remove and
discard
Remove through opening in sleeve; care-
fully and slowly release pressure on
spring; then remove sleeve
Tap third clutch shaft drum and plug as-
sembly on block of wood to remove
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or exces-
sive heat and don’t smoke when using it. Failure to do so could
cause serious injury. If you become dizzy while using cleaning
solvent, get fresh air immediately, and get medical attention. If
contact with skin or clothes is made, flush with large amounts of
water. If contact with eyes is made, wash eyes with water immedi-
ately, and obtain medical aid immediately.
WARNING
Wear safety glasses when drying parts with compressed air. Fail-
ure to do so could cause serious injury to eyes and possible blind-
ness. If you hurt your eyes or if a foreign object is blown into
your eyes, seek medical attention immediately.
4-218
|
