TM  10-3930-638-24&P 4 - 4 .    T R A N S M I S S I O N    M A I N T E N A N C E    ( c o n t ) d. Gear and Clutch Group (cont). STEP LOCATION ITEM ACTION REMARKS REASSEMBLY  (cont) 29 Transmission a. Third clutch assem- Position  and Tap assembly into housing until ring groove housing, rear bly (19) and bear- tap in in housing is aligned with locating ring ing carrier (20) (18). Remove pliers b.  Bearing  carrier Check Ring in full position in ring groove locating ring (18) c. Oil baffle (44) Install 30 Low range a. Low gear bearing (37) Install Use soft hammer to install until flush gear (36) with gear (36) hub b. Bearing spacer (38) Install Use soft hammer to install until flush with bearing (37) c. Low gear bearing (39) Install Use soft hammer to install until flush with gear (36) hub 31 Output  shaft a. Range shift hub (40) Install On output shaft (33) (33) b.  Gear  thrust  washer Install Bevel towards rear cover (42) c. Output shaft rear Install Press onto output shaft until bearing bearing (41) shoulders on washer (42) d. Low range gear (36) Install Press onto output shaft e. Thrust washer (35) Install f. Output shaft front Install Press onto output shaft until bearing bearing (34) shoulders on thrust washer (35) 32 Transmission Output shaft (33) Install housing, rear Change  1 4-183