TM  10-3930-638-24&P 4-2.   ENGINE   MAINTENANCE   (cont) h. Timing Gear Cover (cont). STEP LOCATION ITEM ACTION REMARKS INSTALLATION  (cont) 12 Cylinder  block a.  Cylinder  block Coat Apply Permatex 2 on both sides of cyl- inder block from lower mounting hole,  downwards b. Gasket (30) Install  and Apply Permatex 2 to open face of gasket coat from lower mounting hole, downwards 13 Cylinder block Timing gear cover (27) Position 14 Timing gear a. Cap screw (21) Install 1-1/4 inch long cap screw; install in cover (27) and washer (25) cover boss 1, 2, and 9. Tighten to 25-30  pounds  foot  torque b. Three cap screws Install 3-1 /4 inch long cap screw; install in cover (19),  washers  (20), boas 3,4, and 5. Tighten to 25-30 pounds washers  (18),  and foot torque nuts  (17) c. Cap screw (22) and Install 1-1/2 inch long cap screw; install in cover two washers (25 and boss 8. Tighten to 25-30 pounds foot 26) torque d. Cap screw (23) and Install 2-3/4 inch long cap screw; install in cover washer (25) boss 7. Tighten to 25-30 pounds foot torque e. Cap screw (24) Install 3 inch long cap screw; install in cover boss and  washer  (25) 6. Tighten to 25-30 pounds foot torque f. Two cap screws (15) Install Tighten  to  25-30  pounds  foot  torque and lock washers (16) g. Gasket (30) Trim Cut off any protruding gasket from bottom of cylinder block. Gasket must be flush with  cylinder  block Change   1   4-65