TM  10-3930-638-24&P 4-2.   ENGINE   MAINTENANCE   (cont) f. Pistons and Connecting Rods (cont). STEP LOCATION ITEM ACTION REMARKS INSTALLATION  (cont) 19 NOTE (cont) In following step, be sure number on connecting rod cap (2) matches number on connecting rod (3). c.  Connecting  rod  cap Position (2)  and  bearing liner (12) d. Two connecting Install  and Tighten to 45-50 pounds foot torque, then rod nuts (1) remove remove e.  Connecting  rod Remove cap (2) f. Plasti gage Measure Flattened  plasti  gage  located  on  bearing liner (12) or crankshaft connecting rod journal. Clearance shall be between 0.0010 to 0.0040 inch. Install undersize bearing liner kit and regrind crankshaft journals (para 4-2d) if clearance exceeds 0.0040  inch g. Crankshaft con- Lubricate Use No. 30 oil netting  rod journals h. Connecting rod Lubricate  and Use No. 30 oil; be sure numbers on caps (2) cap (2), bearing position cap and connecting rod (3) match liners (12) i. Two connecting Install Tighten to 45-50 pounds foot torque rod nuts (1) 20 Cylinder block, Cylinder liner re- Remove Installed in step 4C of  removal top taining cap screws and  washers 4-51