TM  10-3930-638-24&P 3-13.   STARTER   AND   SOLENOID   REPAIR   (cont) If removed Engage with drive assembly STEP LOCATION ITEM ACTION REMARKS REASSEMBLY (cont) 22 g. Stop collar (13) Install Force stop collar over retaining ring. Place (cont) a suitable washer over retaining ring. Squeeze collar and washer together using pliers. Remove and discard washer h. Washer (12) Install i. Washer (1 1) Install 23 Drive hous- a. Sleeve bearing (34) Install ing (53) b. Pin (33) Install c. Armature  (10) Install d. Two lock washers Position (9) e. Two screws (8) Install f. Shift lever (30) Install g. Two seal washers Position (29) h. Screw (28) Install i. Nut (27) Install j. Boot (31) Seal  and Apply sealer to drive housing frame position k. Plunger (32) Position On shift lever (30) l. Spring pin (26) Install Press on plunger (32) and shift lever (30) m.  plunger  spring Position Over  plunger  (32) (25) n.  Solenoid  switch  (24) Position Against  drive  housing  (53) o. Two lock washers Install  and Until solenoid (24) is securely mounted (23) and screws tighten (22) p. Field frame (7) Position Over  armature  (10) CAUTION Use care to not damage brushes when positioning frame over armature. q. Field frame (7) and seal Apply  sealer  between  frame,  solenoid  flange solenoid  switch and solenoid junction (24) 3-111