TM  10-3930-638-24&P 3-13.   STARTER   AND   SOLENOID   REPAIR This task covers: a.  Disassembly d. Testing b. Cleaning e.  Reassembly c. Inspection INITIAL  SETUP TOOLS EQUIPMENT   CONDITION No. 1 Common Organiza- NSN  4910-00-754-0654 Paragraph Condition Description tional  Maintenance  Tool  Kit 2-27a Starter  and  solenoid  removed  from vehicle. MATERIALS/PARTS Cleaning  solvent  P-D-680 Clean  cloths Gasket Oil seal Lubricant (FSCM 16764 P/N 1960954) Engine oil (MIL-L-2104, SAE grade 10) Sealer  (FSCM  16764  P/N1050026) STEP LOCATION ITEM ACTION REMARKS DISASSEMBLY 1 Drive housing a. Screw (1) Remove (53) b. Connector (2) Detach From  solenoid  (24) c. Two through bolts (3) Remove d. End frame (4) Remove e. Pipe plug (5) and Remove From end frame (4) wick (6) f. Two screws (8) and Remove lock washers (9) g. Armature (10) Remove 2 Armature (10) a. Washer (11) Remove  and and  drive  as- discard sembly  (15) b. Washer (12) Remove  and discard c. Stop collar (13) Press forward Use a 1/2 inch pipe coupling, or an old pinion,  to  press  collar  toward  armature to expose retaining ring (14) d. Retaining ring (14) Remove Use  pliers e. Stop collar (13) Remove f. Drive assembly (15) Remove From armature shaft g. Washer (16) Remove  and discard h. Center bearing as- Remove sembly  (17) 3-102