TM  10-3930-638-24&P 3-5.   ENGINE   MAINTENANCE   (cont) j.  Rocker  Arm  Assembly  (cont). STEP LOCATION ITEM ACTION REMARKS reassembly  AND  INSTALLATION/REPLACEMENT 10 Engine  cylinder a. All parts Lubricate Lightly coat with oil head b. Eight push rods Install In cylinder head bores c.  Center  bracket  (10) Position On  cylinder  head d. Washer (2) and cap Install and Hand-tighten only, to secure center screw  (9) tighten bracket  (10) NOTE Intermediate brackets (11) are installed on cylinder head with slanted side toward  pushrods. e. Intermediate brackets Install On shafts (12). Front shaft is installed with (11) short end of shaft (as measured from shaft cut-out) toward fan end of engine, Rear shaft is installed with short end of shaft toward starter end of engine Push on long end of shafts (12). Be sure slant of rocker arms is correct as shown f. Spring (8) and rocker Install arms (6 and 7) Change  1 3-65

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business