TM   10-3930-638-24&P 2-56. HYDRAULIC LIFT SYSTEM MAINTENANCE (cont) g. Hydraulic Reservoir (cont). (5) Removal and Installation (cont). STEP LOCATION ITEM ACTION REMARKS CLEANING WARNING Dry cleaning solvent (P-D-680). used to clean parts is toxic and flammable.  Wear  protective  goggles  and  gloves  and  use  only  in  a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immed- iately,  and  obtain  medical  aid  immediately. 5 Hydraulic reservoir (20) Clean  exterior Use  cleaning  solvent  P-D-680 6 Hydraulic  reservoir  (20) Clean  interior Use  steam INSPECTION 7 Hydraulic  reservoir  (20) Inspect Check for cracks, breaks, dents and corrosion 8 Hydraulic a.  Dents Hammer  out reservoir WARNING When welding hydraulic reservoir, partially fill it with water. Failure to do so may cause serious injury or death. b. Cracks, breaks, leaks, Weld or  corrosion  damage INSTALLATION/REPLACEMENT 9 Rear  chassis, Hydraulic  reservoir  (20) position,  remove  chain front hoist.  Slide  into position  until mounting  holes are  aligned 2-453