TM  10-3930-638-24&P 2-56.   HYDRAULIC   LIFT   SYSTEM   MAINTENANCE   (cont) 7 STEP LOCATION ITEM ACTION REMARKS INSTALLATION/REPLACEMENT   (cont) f. Sideshift chain (5) Soak chain in SAE 10 motor oil, then position. Insert chain (Cont) bolt in sideshift cylinder support hole g. Sideshift chain nut (4) Install h. Sideshift chain (3) Soak chain in SAE 10 motor oil, then position. Insert chain bolt in hole on right side of sideshift assembly i. Sideshift chain nut (2) Install j. Sideshift chain (5) Route chain around and down inner pulley mounted in side- shift cylinder rod fork, to pulley on left of side shift assembly, around and down pulley to carriage assembly. Insert chain bolt in chain mounting lug on carriage assembly k. Sideshift chain (3) Route chain around and down outer pulley mounted in sideshift cylinder rod fork, to pulley on right of sideshift assembly around and down pulley to carriage assembly. Insert chain bolt in chain mounting lug on carriage assembly 8 Carriage Two sideshift chain nuts Install;  tighten  until  chain  deflects  1/2  inch  when  depressed assembly (1) in middle ADJUSTMENT 9 Carriage a. Sideshift chains Depress in middle Chain deflects 1/2 inch approximately assembly b. Sideshift chain nuts Tighten or loosen as required to obtain 1/2 inch deflection when chain is depressed in middle e. Sideshift Chains and Pulleys (cont). 2-415