TM  10-3930-638-24&P 2-48.    STEERING    SYSTEM    MAINTENANCE    (cont) c. Steering Cylinder Assembly (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL NOTE Removal of either steering cylinder assembly is the same. Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water  immediately,  and  obtain  medical  aid  immediately. 1 Side  of  vehicle  a. b. c. d. e. f. g. h. i. j. k. l. m. Steering cylinder Clean Use  cleaning  solvent  P-D-680 assembly^- ( 12) and hydraulic  connections Tie strap (1) Two hose clamps (2) Steering  cylinder guard (3) Hose fitting (4) Elbow  (5) Hose fitting (6) Elbow  (7) Steering  cylinder assembly (12) Retaining ring (8) Pin (9) Retaining ring (10) Pin (11) n.  Steering  cylinder assembly (12) Remove Loosen  and remove Remove Disconnect  and Prevents intrusion of dirt plug Remove and plug Prevents intrusion of dirt opening  in cylinder ( 12) Disconnect  and Prevents intrusion of dirt plug Remove and plug Prevents intrusion of dirt Support  with chain hoist, or jack stand or appropriate block Remove Remove Remove Remove Remove to clean work area Change  2  2-340