TM  10-3930-638-24&P 2-43.   SERVICE   BRAKE   MAINTENANCE   (cont) e. Brake Pedal and Declutch Pedal (cont). STEP LOCATION ITEM ACTION REMARKS CLEANING  (cont) 3 All parts Clean Use cleaning solvent P-D-680. Dry thor- oughly  with  compressed  air INSPECTION 4 Springs  (3) Inspect Replace if cracked, distorted, or coil broken 5 Pivot pin (8), declutch Inspect Replace if worn, pitted, burred or damaged pedal  (9),  brake  pedal (10). yoke (12) and pins (1 and 2) 6 All hardware Inspect Replace  if  worn,  or  if  threads  damaged REASSEMBLY 7 Pedals  (9 a. Cap screws (15) Position On pedal spring bracket. and  10) b. Two lock nuts (14) Install  and Until screw (15) is securely mounted tighten c. Two lock nuts Install On end of cap screw (15). Do not tighten (14) against inside lock nut (14) or spring bracket  on  pedal d. Two grease fittings Install  and Until fitting (13) is securely mounted (13) tighten INSTALLATION 8 Front chassis, a. Lock nut (11) Install On brake pedal yoke (12) bottom  left b. Brake pedal yoke (12) Install Turn clockwise into brake valve push rod side NOTE Do not tighten lock nut (11) against brake valve push rod at this time. c. Pedals (9 and 10) Position and On  pedal  bracket and pivot pin (8) install d. Eye rod (7) Push in Pivot pin (8) e. Cap screw (6), lock Install  and Until eye rod (7) is securely mounted washer (5) and tighten nut (4) f. Two springs (3) Install g. Brake pedal yoke Position On brake pedal (10) (12) 2-317