TM   10-3930-638-24&P 2-42. PARKING BRAKE MAINTENANCE (cont) a. Parking Brake Linkage (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL  (cont) NOTE Don’t perform following step unless bracket (27) requires replacement. 6 Transmission, a. Two cap screws (25) Remove left  side,  above and six washers (26) parking  brake b. Bracket (27) Remove CLEANING 7 Parking  brake  cable  (8) Clean Use clean diesel fuel WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or exces- sive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water immedi- ately,  and  obtain  medical  aid  immediately. 8 All other parts Clean Use  cleaning  solvent  P-D-680 inspection/REPAIR 9 Parking brake lever (4) Inspect Replace if dented, bent, or lever action is rough 10 Parking  brake  cable  (8) Inspect Replace if clevis mounting holes elongated, or if cable kinked or threads damaged 11 All other parts Inspect Replace if damaged, worn, bent, distorted, or threads damaged INSTALLATION/REPLACEMENT 12 Transmission, a. Bracket (27) Position On transmission rear cover left  side,  above b. Six washers (26) and Install Place three washers (26) on cap screw (25); parking brake two cap screws (25) tighten to 37-41 pounds foot torque 2-273