TM   10-3930-638-24&P 2-42. PARKING BRAKE MAINTENANCE (cont) a. Parking Brake Linkage (cont). STEP LOCATION ITEM ACTION REMARKS INSPECTION 1 Operator’s com- a. Parking brake lever Inspect for loose Tighten loose hardware; replace missing partment (4) or missing hard- hardware ware b. Parking brake cable (8) Inspect for loose Tighten  loose  hardware;  replace  missing or missing hard- hardware ware c. Parking brake lever (4) Apply If linkage seems too loose as indicated by lever  moving  too  freely,  adjust  as described in step 19 below REMOVAL 2 Operator’s com- a. Two nuts (1) and lock Remove partment washers  (2) b. Two cap screws (3) Remove c. Parking brake lever (4) Remove d. Cotter pin (5) Remove e. Washer (6) Remove f. Pin (7) Remove Disconnects  parking  brake  cable  (8)  clevis from lever (4) g. Parking brake cable (8) Disengage From lever (4) h. Two spacers(11) Remove i.  Clamp  (12) Remove j. Clamp spacer(13) Remove 3 Operator’s com- a. Nut (14) and lock Remove partment, rear washer (15) b.  Capscrew(16) Remove c. Clamp (17) Remove 4 Transmission, a. Two nuts (18) and lock Remove left  side  above washers  (19) parking brake b. U bolt (20) Remove c. Parking brake cable (8) Relocate d. Plate (21) Remove 5 Parking  brake a. Cotter pin (22) Remove actuating lever b. Washer (23) Remove c. Clevis pin (24) Remove Disconnects parking brake cable clevis from actuating lever d. Parking brake cable (8) Remove Away from bracket (27) 2-272