| |
TM 10-3930-638-24&P
2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)
b. Center Drive Shaft Assembly (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
SERVICING
1
Universal joints
Three lubrication fittings
a. Clean
Use clean cloth and remove dirt and grease
(3) and slip yoke (4 and 5)
(10)
CAUTION
Don’t use a high pressure grease gun to apply lubricant to grease
fittings (4). Use of a high pressure grease gun will cause seals
to rupture.
b. Lubricate
Refer to current lubrication order;
lubricate until grease oozes out of fitting
REMOVAL
2
Transmission
Four cap screws
Remove
parking brake
flange
3
Drive shaft sup-
s. Four cap screws
Remove
port bearing
b. Center drive shaft
Push two sections
assembly
of center drive
shaft together,
then remove
DISASSEMBLY
4
Center drive
a. Eight nuts (1) and
Remove
shaft assembly
cap screws (2)
b. Two universal joints (3) Remove
c. Two lubrication fittings
Remove
(4)
d. Lubrication fitting (5)
Remove
e. Cap (6)
Loosen and slide
back on splined
yoke (9)
f. Washer (7 and 8)
Slide back on splined
yoke (9)
g. Splined yoke (9)
Remove; then remove
and discard washers
(7 and 8) and cap
(6)
2-239
|