TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) c. Axle Disconnect Lever (cont). STEP LOCATION ITEM ACTION REMARKS INSPECTION 4 Upper  lever  (4)  and Inspect Replace  if  bent  or  cracked;  repair  threads rod (11) by chasing with proper size die 5 Knob (1) Inspect Replace if cracked, chipped or threads damaged 6 Pin (3) Inspect Replace if bent or cracked 7 Clamps (8 and 16) Inspect Replace  if  cracked 8 Bracket (19) Inspect Replace if bent, cracked, or spacer damaged INSTALLATION 9 Transmission a.   Bracket Position b. Two lock washers (18) Install Tighten to 37-41 pounds foot torque and cap screws (17) c. Clamp (16) Position On  dipstick  assembly d. Cap screw (15) Position Secures clamp (16) to bracket (19) e. Washer (14), lock Install washer  (13),  and  nut (12) f. Rod (11) Position In bracket(19) g. Washer (10) Position On rod (11) h. Cotter pin (9) Install Bend  over i. Clamp (8) Position On rod (11); line up holes in clamp with holes in shift rod j. Cap screw (7) Position k. Lock washer (6) and Install nut (5) 10 Operator’s  com- a. Upper lever (4) Position partment, rear b. Pin (3) Install c. Cotter pin (2) Install d. Knob (1) Install e. Front cover panel Install On rod (11) Bend  over Para  2-53f 2-224