TM  10-3930-638-24&P 2-38.   TRANSMISSION   MAINTENANCE   (cont) b.  Transmission  Linkage  Controls  (cont). STEP LOCATION ITEM ACTION REMARKS INSPECTION 1 Instrument  panel, a. Speed control lever Inspect for loose Tighten loose parts; replace missing parts bottom, trans- or missing parts mission  control b.  Direction  control Inspect for loose Tighten loose parts; replace missing parts levers lever or missing parts 2 Engine  compart- Linkage  (at  control  valve) a. Inspect for Tighten loose parts; replace missing parts ment loose or missing  parts b. Check that If necessary, disassemble and inspect parts when levers if control valve spools do not move are moved, linkage causes control  valve spools to move REMOVAL 1 Instrument panel, a. Nut (1) Remove bottom.  speed b. Lock washer (2) Remove control lever c. Ball joint (3) Detach and remove From cable (53) d. Nut (4) Remove from ball joint  (3) e. Nut (5) Remove f. Two washers (6 and 13) Remove g. Nut (7) Remove  and  sup- port bracket (8) h. Washer (9) Remove i. Bracket (8) Remove j. Spring (10) Remove k. Spacer (11) Remove l. Cap screw (12) Remove m. Nut (14) Remove n. Speed control lever (15) Remove o. Control lever knob (16) Remove 2 Instrument panel, a. Cotter pin (17) Remove bottom, direction b. Clevis pin (18) Remove control lever c. Clevis (19) Detach  and  remove from cable (54) d. Nut (20) Remove e. Cap screw (21) Remove f. Two washers (22) Remove g. Control lever knob (23) Remove h. Direction control lever Remove (24) i. Two nuts (25) Remove j. Two cables (53 and 54) Loosen nuts, detach from bracket and mark for proper installation 2-215