| |
TM 10-3930-638-24&P
2-33. BATTERY SYSTEM MAINTENANCE (cont)
h. Battery Cables and Batteries (cont).
STEP
LOCATION
ITEM
ACTION
REMARKS
REMOVAL
1
Battery compart- a. Ground cable
Remove from
Loosen clamp nut, spread clamp terminal
ment, rear of
clamp (1)
battery post
and lift from battery post
vehicle
b. Battery cable clamps
Remove from
Loosen clamp nuts, spread clamp
(3) and positive
battery posts
terminals and lift from battery posts
cable (2)
c. Two cap screws (4)
Loosen and
remove
d. Two hold-down
Remove
Lift from batteries
straps (5)
e. Two batteries (6)
Remove
Lift from battery compartment
f. Positive cable
Remove
From starter solenoid B terminal
terminal (7)
(para 2-27a)
g. Ground cable
Remove
From starter housing (para 2-27a)
terminal (8)
h. Nut (9), lock washer
Remove
From clamp (12)
(10) and cap screw (11)
i. Clamp (12)
Remove
Spread and lift from harness and battery
cables
j. Two grommets (13)
Remove
and cables (1 and 3)
CLEANING
WARNING
Dry cleaning solvent (P-D-680), used to clean parts is toxic and
flammable. Wear protective goggles and gloves and use only in a
well ventilated area. Avoid contact with skin, eyes, and clothes
and don’t breathe vapors. Do not use near open flame or
excessive heat and don’t smoke when using it. Failure to do so
could cause serious injury. If you become dizzy while using
cleaning solvent, get fresh air immediately, and get medical
attention. If contact with skin or clothes is made, flush with large
amounts of water. If contact with eyes is made, wash eyes with
water immediately, and obtain medical aid immediately.
WARNING
Wear safety glasses when drying parts with compressed air.
Failure to do so could cause serious injury to eyes and possible
blindness. If you hurt your eyes or if a foreign object is blown
into your eyes, seek medical attention immediately.
2
Straps (5), clamp (12)
Clean
Use cleaning solvent P-D-680.
and hardware
Dry thoroughly with compressed air
3
Cables (1, 2 and 3) and
Clean
Wipe with a clean, dry cloth
grommet (13)
2-185
|