TM    10-3930-638-24&P 2-30. LIGHT SYSTEMS MAINTENANCE (cont) c.  Rear.  Blackout  Lights. This  task  covers:  a.  Removal b.  Cleaning c.    Inspection INITIAL  SETUP TOOLS No.  1  Common  Organiza- NSN  4910-00-754-0654 tional Maintenance Tool Kit MATERIALS/PARTS Cleaning  solvent  P-D-680 Clean  cloths d.  Installation/  Replacement e.  Testing EQUIPMENT CONDITION Paragraph Condition Description Engine  off. IGNITION switch in OFF position and key  removed. 2-52c Tow bar lowered to ground and grille open. STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Rear of vehicle a. b. c. d. e. f. g. h. i. j. k. Six  screws  (1) Door (2) and gasket (3) Two bulbs (4) Two  harness connectors (6) Two cap screws (7) and lock  washers  (8) Body  (13) Five screws (9 and 11) and two washers (10) Socket  assembly  (12) Six rings (5) Six  screws  (1) Grommet (14) Loosen Remove Depress, turn counterclock- wise  and  remove Grasp  and  pull Remove Remove Remove Remove Remove Remove Remove From  light  assembly Support  body  (13) leads Support  socket  assembly  (12) From  body  (13) From screws (1) From  door  (2) CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well  ventilated  area.  Avoid  contact  with  skin,  eyes,  and  clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning  solvent,  get  fresh  air  immediately,  and  get  medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water  immediately,  and  obtain  medical  aid  immediately. 2-150