TM  10-3930-638-24&P 2-30. LIGHT SYSTEMS MAINTENANCE (cont) a. Flood Lights (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Front or rear a. Rubber gasket (1) Pull  inserts From cut outs in housing (9) b. Rubber gasket (1) Pull  and  remove From housing (9) and lamp (3) c. Wire leads (2) Tag,  grasp  and From lamp (3); set lamp (3) aside pull d. Connector (4) Grasp  and  pull From harness lead e. Seal (5) Grasp  and  pull Not  used  on  instrument  panel-mounted from nut (6) flood lights or rear flood lights f. Nut (6), lock washer Remove Support housing (9) (7) and washer (11) g. Housing and spacer Remove Seal  (8)  not  used  on  instrument  panel- (9) and seal (8) mounted flood lights h.  Grommet  (10) Remove From ROPS CLEANING WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well  ventilated  area.  Avoid  contact  with  skin,  eyes,  and  clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning solvent, get fresh air immediately, and get medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water  immediately,  and  obtain  medical  aid  immediately. 2 Wire  connectors  and Clean Use cleaning solvent P-D-680 on terminals connectors  and  terminals  only 3 Gasket (1), seals (5 and 8) Clean Wipe with a clean, dry cloth and  grommet  (10) WARNING Wear safety glasses when drying parts with compressed air. Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into  your  eyes,  seek  medical  attention  immediately. 4 Housing  (9)  and Clean Use  cleaning  solvent  P-D-680. hardware (6, 7 and 11) Dry thoroughly with compressed air INSPECTION 5 All  hardware Inspect Replace if worn, or if threads damaged CHANGE   2   2-145