TM  10-3930-638-24&P 2-27. STARTING SYSTEM MAINTENANCE (cont) a. Starter (cont). STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Engine  compart- a. Nut (1), lock washer Remove From solenoid switch S terminal ment rear, left (2) and wire (3) side  of  vehicle b. Nut (4), lock washer Remove From  solenoid  switch  B  terminal (5), two cables (6 and 7) and wire (8) c. Three cap screws (9), Remove Support starter (12) lock washers (10) and ground cable (11) d. Starter (12) Remove From  engine CLEANING 2 Starter (12) Clean Wipe exterior with clean, dry cloth WARNING Dry cleaning solvent (P-D-680), used to clean parts is toxic and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning  solvent,  get  fresh  air  immediately,  and  get  medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water  immediately,  and  obtain  medical  aid  immediately. 3 Wires (3 and 8) and Clean Use cleaning solvent P-D-680 on cables (6, 7 and 11) connectors only WARNING Wear safety glasses when drying parts with compressed air. Failure to do so could cause serious injury to eyes and possible blindness. If you hurt your eyes or if a foreign object is blown into  your  eyes,  seek  medical  attention  immediately. 4 All hardware Clean Use  cleaning  solvent  P-D-680. Dry  thoroughly  with  compressed  air INSPECTION 5 All  hardware Inspect Replace if worn, or if threads damaged 6 Wires (3 and 8) and Inspect Replace if insulation frayed, or if cables (6, 7 and 11) conductors broken 2-120