TM  10-3930-638-24&P 2-26.   ALTERNATOR   MAINTENANCE   (cont) STEP LOCATION ITEM ACTION REMARKS REMOVAL 1 Engine  compart- a.  Nut  (1),  lock  washer(2)  Remove From BATT terminal ment rear, left and wire lead (3) side  of  vehicle b. Push-on connector (4) Grasp and From terminals 1, 2 and R disconnect c. Cap screw (5), lock Remove washer (6) and washer (7) d. Nut (8), lock washer Remove Support  alternator  (11) (9) and cap screw (10) e.  Alternator  (11) Remove 2 Alternator Nut (12), lock washer Remove Use pulley puller (13),  pulley  (14) and fan (15) 3 Engine  compart- a. Cap screw (16), lock Remove From  engine ment rear left washer (17), strap side  of  vehicle (18)  and  spacer  (19) b. Cap screw (20), lock Remove From  engine washer (21) and bracket (22) c. Retainer halves (23) Push together, Remove  resistor  (24) turn and separate d. Tie strap (25) Cut and remove From harness and diode (26) e.  Diode  (26) Unplug  and remove CLEANING WARNING Dry  cleaning  solvent  (P-D-680),  used  to  clean  parts  is  toxic  and flammable. Wear protective goggles and gloves and use only in a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you become dizzy while using cleaning  solvent,  get  fresh  air  immediately,  and  get  medical attention. If contact with skin or clothes is made, flush with large amounts of water. If contact with eyes is made, wash eyes with water  immediately,  and  obtain  medical  aid  immediately. 2-115

Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business