CLEANING - TM-10-3930-638-24-P0988

TM 10-3930-638-24&P

4-4.

TRANSMISSION

MAINTENANCE

(cont)

g. Low Clutch Assembly (cont).

ITEM

REMARKS

ACTION

LOCATION

STEP

CLEANING

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immedi-

ate] y, and obtain medical aid immediately.

WARNING

Wear safety glasses when drying parts with compressed air. Fail-

ure to do so could cause serious injury to eyes and possible blind-

ness. If you hurt your eyes or if a foreign object is blown into

your eyes, seek medical attention immediately.

Use cleaning solvent P-D-680. Immerse

Eearings (2,4,8)

Clean

bearings in cleaning solvent and move

slowly up and down. Remove bearings.

Strike larger side of cone against block

of wood to dislodge solidified particles

of lubricant, Immerse again in cleaning

solvent. Repeat this process until bear-

ings are thoroughly clean, Dry bearings

with moisture-free compressed air. Direct

air stream across bearing. Do not spin

the bearings when drying. Rotate bear-

ings slowly by hand to facilitate drying

Use cleaning solvent P-D-680. Immerse

Clean

All parts

parts in cleaning solvent and move slow-

ly up and down until parts are thoroughly

cleaned. Dry parts thoroughly using com-

pressed air or clean cloths

4-210