REASSEMBLY (cont) - TM-10-3930-638-24-P0680

TM 10-3930-638-24&P

3-24. STEERING SYSTEM MAINTENANCE (cont)

b. Steering Gear (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

REASSEMBLY (cont)

NOTE

(cont)

Use original shims (17) unless cracked or damaged. Replace a

defective shim with a new shim of equal thickness.

d. Shims (17)

Install

Place on tip of thrust washer (22)

e. New O-ring(15)

Lubricate

Coat with clean grease and insert in

and install

counterbore of upper cover

NOTE

If original upper cover (14) is used, align match marks on upper

cover and housing (43). If a new upper cover is used, disregard

match mark on housing.

f. Upper cover (14)

Position

Over input shaft (27) and onto housing (43

g. Four cap screws (13)

Install and

Tighten hand-tight only

tighten

h. Upper cover (14)

Align

Position worm type hose clamp around

and housing (43)

flange of upper cover (14) and outside

diameter pilot of housing (43). Tighten

clamp to achieve upper cover and housing

alignment

i. Four cap screws (13)

Tighten

Alternately tighten to 18-22 pounds foot

torque

CAUTION

To prevent distortion of steering gear, do not clamp vise jaws di-

rectly on steering gear housing (43).

j. Housing (43)

Reposition

Clamp O-ring fitting in vise so that input

and clamp

shaft (27) faces downward

k. Drive link (10)

Install

Pull input shaft (27) downward and prevent

rotation, engage splines on drive link (10)

in spool (30), and rotate drive link to

position spool end flush with end of hous-

ing (43). Remove drive link, reposition

to allow drive link slot to engage pin on

torsion bar, and insert drive link

3-174