Steering Gear (cont). - TM-10-3930-638-24-P0670

TM 10-3930-638-24&P

3-24. STEERING SYSTEM MAINTENANCE (cont)

b. Steering Gear (cont).

ITEM

LOCATION

STEP

REMARKS

ACTION

DISASSEMBLY (cont)

Loosen and

c. Seven hex bolts (2)

(cont)

remove

CAUTION

Do not attempt to remove guide pin from inside center of end

cover (3). Guide pin is press fit in the end cover and is not ser-

viceable separately.

Loosen and

d. End cover (3)

Lightly tap sides with soft hammer to

remove

loosen from rotor seal (4) and seal retain-

er (5). Washer (6) and commutator (7)

may be removed with end cover (3)

Housing (43)

a. Rotor seal (4) and

Remove

Loosen seal retainer (5) by bumping side-

seal retainer (5)

ways with a soft hammer, and remove

seal (4) and retainer (5). Discard seal (4)

b. Wear washer (6)

Remove

From housing (43) or end cover (3)

and commutator (7)

c. Commutator ring (8)

Remove from

Remove with a sliding and lifting motion

manifold (9)

d. Manifold (9)

Remove from

Remove with a sliding and lifting motion

rotor set (11)

CAUTION

Rotor set (11) requires special attention in handling to avoid

nicks and scratching. When handling rotor set, apply pressure to

rotor by grasping rotor and urging into contact with stator.

e. Rotor set (11),

Remove as an

Grasp spacer (12) and remove assembly

spacer (12) and

assembly

with a sliding and lifting motion

drive link (10)

3-164