Center Drive Shaft Assembly (cont). - TM-10-3930-638-24-P0278

TM 10-3930-638-24&P

2-39. AXLES AND DRIVE SHAFT ASSEMBLIES MAINTENANCE (cont)

b. Center Drive Shaft Assembly (cont).

REMARKS

ITEM

ACTION

LOCATION

STEP

INSTALLATION/REPLACEMENT

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes. and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

Use clean cloth moistened with cleaning

a. Mounting surfaces

Clean

Drive shaft sup-

solvent P-D-680

port bearing

Position and align

b. Slip yoke (10)

universal joint

mounting holes

with front drive

shaft yoke

mounting holes

Tighten to 40-50 pounds foot torque

c. Four cap screws

WARNING

Dry cleaning solvent (P-D-680), used to clean parts is toxic and

flammable. Wear protective goggles and gloves and use only in a

well ventilated area. Avoid contact with skin, eyes, and clothes

and don't breathe vapors. Do not use near open flame or exces-

sive heat and don't smoke when using it. Failure to do so could

cause serious injury. If you become dizzy while using cleaning

solvent, get fresh air immediately, and get medical attention. If

contact with skin or clothes is made, flush with large amounts of

water. If contact with eyes is made, wash eyes with water immed-

iately, and obtain medical aid immediately.

Use clean cloth moistened with cleaning

a. Mounting surfaces

Clean

Transmission

solvent P-D-680

parking brake

Position; push/pull

flange

b. Splined yoke (9)

two sections of drive

shaft then align uni-

versal joint mounting

holes with brake

flange mounting holes

Install

Tighten to 40-50 pounds foot torque

c. Four cap screws

Service

Refer to step 1 above

Lubrication fittings

Center drive

shaft assembly

2-242